OptiMate MONITOR O-126 SAE to Auto 12V socket adapter

Battery status / charge system monitor for 12V lead-acid, with AUTO plug.
SAE to Auto 12V socket adapter with state of charge monitor that plugs directly into your motorcycle, ATV/SxS, car, pick-up truck or boat’s 12V power port – Adapter with 24-7 battery status at a blink of an LED!

    Plug fits any standard Ø21-22mm / 7/8″ 12V cigar / power socket that remains powered / hot when ignition is off, with integrated 10A fuse to protect electronics.
    Sealed monitor with 4 LEDs indicate battery state of charge from full to empty for 12V 12V lead-acid (AGM, GEL or STD) batteries – LED corresponding to charge level blinks every 3 seconds.
    SAE quick connect charge port for charging battery when needed – with weatherproof sealing cap when vehicle is moving!
    Displays charge system status when engine is running – easy pre-run check at a glance to see if battery is receiving charge.

Smart battery lead that measures voltage; monitors charge of a stored 12V Lead-Acid battery and confirm if the vehicle charging system is working correctly. Fits any Ø21mm AUTO socket.

LENGTH: 10”/25cm

BATTERY CONNECTOR: Ø21mm AUTO plug

CHARGE CONNECTOR: 2-pin SAE, protected from dirt and liquid with rubber sealing cap and shroud.

OPERATION: 2 automatic Modes – Battery charge level monitor (single LED blink mode) & Charging system test (arrow mode).

    Vehicle storage: 4 LEDs cover ‘full to empty’ voltage range of all 12V batteries, including higher voltage AGM for automotive (4th √√LED ≥ 12.7V). (long term draw less than 0.2mA).
    Vehicle running: LED arrow mode activates when charge voltage reaches a minimum of 13.5V (√ green LED) or ideal range of 14V+ (√√ green LED).


CABLE RATING: 18AWG (0.82mm2) SPT-2

FUSE: 10 Amp (inside the connector)

USE: -40°C/-40°F very low temperature, remains flexible at ‘below freezing’ temperatures

STYLE: Fully enclosed electronic circuitry with 4 LEDs, SAE charge connector with rubber sealing cap & shroud